您的位置: 标准下载 » 协会标准 » IEC 国际电工委员会 »

IEC 60099-6-2002 避雷器.第6部分:额定电压等于或低于52kV的含有串联及并联间隙结构的避雷器

作者:标准资料网 时间:2024-05-21 19:45:28  浏览:9289   来源:标准资料网
下载地址: 点击此处下载
【英文标准名称】:Surgearresters-Part6:Surgearresterscontainingbothseriesandparallelgappedstructures;Rated52kVandless
【原文标准名称】:避雷器.第6部分:额定电压等于或低于52kV的含有串联及并联间隙结构的避雷器
【标准号】:IEC60099-6-2002
【标准状态】:现行
【国别】:国际
【发布日期】:2002-08
【实施或试行日期】:
【发布单位】:国际电工委员会(IX-IEC)
【起草单位】:IEC/TC37
【标准类型】:()
【标准水平】:()
【中文主题词】:额定电压;装置;过电压保护装置;电阻;额定电压装置;过电压;电气保护设备;验收检验;电涌放电器;额定值;过载试验;过载(电);常规检验;串联;交流电网络;火花间隙;并联;电阻器;疏水器;非线性的;地电阻;交流电压;电气工程;测量;使用条件;作标记;定义;定义;金属氧化避雷器;测量技术;安全工程;合格试验;分类;规范(验收);试验
【英文主题词】:installations;earthresistance;seriesconnection;marking;safetyengineering;classification;definition;qualificationtests;acceptanceinspection;traps;measuringtechniques;ratedvoltages;overvoltage;electricalprotectionequipment;metaloxidearresters;overload(electric);overvoltageprotection;installationsforratedvoltages;electricalresistance;alternatingvoltages;specification(approval);resistors;routinechecktests;electricalengineering;testing;non-linear;alternatingcurrentnetworks;measurement;ratings;parallelconnection;definitions;operatingconditions;surgearresters;overloadtests;sparkgaps
【摘要】:ThispartofIEC60099appliestonon-linearmetal-oxideresistortypesurgearresterswithsparkgapsdesignedtolimitvoltagesurgesona.c.powercircuits.Itappliestoallmetal-oxidesurgearresterswithgapsandhousedineitherporcelainorpoly
【中国标准分类号】:K49
【国际标准分类号】:29_240_10
【页数】:46P.;A4
【正文语种】:英语


下载地址: 点击此处下载
【英文标准名称】:Freezedryingofsubstancesofbiologicaloriginformedicaluse;methods
【原文标准名称】:医用生物源物质的冷冻干燥.方法
【标准号】:DIN58350T.2-1979
【标准状态】:作废
【国别】:
【发布日期】:
【实施或试行日期】:
【发布单位】:德国标准化学会(DE-DIN)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:
【英文主题词】:
【摘要】:
【中国标准分类号】:
【国际标准分类号】:
【页数】:
【正文语种】:


MIL-HDBK-704-2, DEPARTMENT OF DEFENSE HANDBOOK: GUIDANCE FOR TEST PROCEDURES FOR DEMONSTRATION OF UTILIZATION EQUIPMENT COMPLIANCE TO AIRCRAFT ELECTRICAL POWER CHARACTERISTICS SINGLE PHASE, 400 Hz, 115 VOLT (PART 2 OF 8 PARTS) (9 APR 2004)., This handbook provides guidance on test procedures for demonstration of single phase, 400 Hz, 115 volt utilization equipment to determine compliance with the applicable edition of MIL-STD-704. 3. MIL-HDBK-704-2 is Part 2 in a series of 8 Parts. Part 2 describes the test methods and procedures to demonstrate that single phase, 400 Hz, 115 volt utilization equipment is compatible with the electric power characteristics of MIL-STD-704. These series of handbooks and MIL-STD-704 are companion documents.